2.16 DDEC III/IV ELECTRONIC CONTROL MODULE The hand-held DDR is used on engines equipped with DDEC III/IV to display engine description, diagnostic data, fault codes, and to program the ECM calibration. A printout of the information displayed on the DDR, can be obtained by attaching a printer. The diagnostic data reader kit (J–38500–D) includes a reader, cable, carrying case, DDEC cartridge, manual, and a six-pin adaptor. See Figure 2-91. Figure 2-91 The DDR and Printer The SAE Standard Communications of the DDEC III/IV system are listed in Table 2-11. The fan control inputs and outputs for DDEC III/IV are listed in Table 2-12.
The engine brake control features of DDEC III/IV are listed in Table 2-13. DDEC III/IV can identify faulty components and other engine-related problems by providing the technician with a diagnostic code. A comparison of DDEC II and DDEC III/IV engine hardware is listed in Table 2-14. A comparison of DDEC II and DDEC III/IV standard sensors is listed in Table 2-15 and a comparison of optional sensors is listed in Table 2-16.
SAE Standard Communication SAE J1587 protocol on J1708 hardware Diagnostics Electronic dashes Data Hub SAE J1922 protocol on J1708 hardware Traction control systems Transmission controls SAE J1939 high speed data link Vehicle controls Table 2-11 SAE Standard Communications for DDEC III/IV (Rev. 2005) All information subject to change without notice. 2-144 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION