Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

2.17 DDEC II ELECTRONIC CONTROL MODULE The DDEC II ECM is packaged in a die-cast aluminum housing with sealed connectors. See Figure 2-85. It is mounted on the left side of the engine block. The DDEC II consists of the following: The DDEC II ECM A replaceable EPROM Connections to various engine sensors, operational displays, power and fuel injectors 2.17.1 Replacement of the DDEC II Electronic Control Module The DDEC II ECM is a sealed, nonserviceable unit. Tag defective ECM for recore. 2.17.2 Diagnostic Procedures Basic mechanical checks should be made beforehand to verify that the problem is definitely related to the electrical portion of the system.

If the basic mechanical checks fail to locate the problem, refer the Detroit Diesel Single ECM Troubleshooting Manual, (6SE497). Start by reading the "Basic Knowledge Required" section before attempting to diagnosis electrical faults. There are two diagnostic Data Readers (DDR) that can be used for diagnosis of DDEC I and DDEC II engines. See Figure 2-93 and see Figure 2-94. Figure 2-93 DDEC I & II Reader (Rev. 2005) All information subject to change without notice. 2-150 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION