SERIES 60 SERVICE MANUAL Figure 2-94 DDEC II & III/IV Reader 2.17.3 Removal of DDEC II Electronic Control Module Perform the following steps for ECM removal: 1. Carefully disengage the lock tab on the power harness and injector harness connectors. 2. Remove the five (5) wire harness connections at the ECM. 3. Remove the through-bolts holding the ECM to the engine. 4. Remove the ECM and cold plate from the engine, if so equipped. 5. Remove the screws securing the cold plate to the ECM. Remove the cold plate from the ECM, if so equipped. 2.17.4 Installation of DDEC II Electronic Control Module Perform the following steps for ECM installation: 1.
Install the cold plate on the ECM, if so equipped. Tighten the screws securing the cold plate to the ECM. Use Loctite® 262, or equivalent, on the cold plate-to-ECM screws. Torque to 9.5-12 N·m (84-106 lb·in.). 2. Inspect the ECM isolators for damage and replace if required. 3. Mount the ECM and cold plate to the engine. 4. Secure the ECM to the engine with through-bolts. Torque the ECM-to-engine bolts to 23-27 N·m (17-20 lb·ft). Torque the ECM connector hold-down screws to 2.4-3.0 N·m (21-26 lb·in.). 5. Connect the five (5) wire harness connections at the ECM. 6. Engage the lock tab on the power harness and injector harness connectors. All information subject to change without notice. (Rev.
2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-151