Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

2.19 PROGRAMMABLE READ-ONLY MEMORY (PROM) DDEC I 2.19.1 Replacement of the DDEC I PROM The PROM is not repairable, it must be replaced. 2.19.2 Removal of PROM Perform the following steps for PROM removal: 1. Remove the ECM. Refer to section 2.18.2. 2. Remove the four PROM access cover screws. 3. Using the rocker type PROM removal tool (J–35889–A), engage one end of the PROM carrier with the hook end of the tool. See Figure 2-104. Figure 2-104 Removing PROM 4. Press on the vertical bar end of the tool and rock the engaged end of the PROM carrier up as far as possible. 5. Engage the opposite end of the PROM carrier in the same manner and rock this end up as far as possible.

Repeat this process until the PROM carrier and PROM are free of the socket. When done correctly, the PROM and carrier should easily lift free of the socket. (Rev. 2005) All information subject to change without notice. 2-166 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION