2.19 PROGRAMMABLE READ-ONLY MEMORY (PROM) DDEC I NOTICE: Do NOT press on the PROM. To avoid damaging the PROM, press on the carrier. 3. Press on the PROM carrier until it is firmly seated in the socket. See Figure 2-106. Figure 2-106 Installing PROM 4. Reinstall the access cover screws. 5. Place a security label over the access cover next to the original label. 6. Reinstall the ECM in the vehicle and plug in the connectors. 7. Tighten the connector hold-down screws. NOTE: In the event the PROM is defective, the DDL reader will not function. The check engine light must be used to read malfunction codes. 8. Turn the ignition to the ON position. Observe or read any diagnostic codes. 9.
If code 51 occurs, check for the following conditions: If it is necessary to check the PROM, follow removal instructions. If not fully seated, press firmly on the carrier. If pins are bent, remove the PROM, straighten pins, and reinstall the PROM. If bent pins break or crack during straightening, discard the PROM and replace it. If found defective, replace the PROM. If the PROM is installed backwards, replace it. (Rev. 2005) All information subject to change without notice. 2-168 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION