Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

2.20 ELECTRONIC DISTRIBUTOR UNIT DDEC I 2.20.1 Replacement of the Electronic Distributor Unit The EDU is a sealed unit that must be replaced. 2.20.2 Removal of Electronic Distributor Unit Remove the EDU as follows: 1. Disconnect the fuel line (at the secondary fuel filter) that runs from the EDU cold plate. Position the line over a suitable container to collect any fuel coming from the system. 2. Disconnect the inlet and return lines from the EDU cold plate. 3. Loosen, but do not remove, the two wire harness connector hold-down screws. Pull gently on the connectors to disengage them from the EDU sockets. 4. Remove the through-bolts and washers holding the EDU to the engine. 5.

Remove the EDU and cold plate from the engine. 6. Remove the screws securing the cold plate to the EDU. Remove the cold plate from the EDU. (Rev. 2005) All information subject to change without notice. 2-170 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION