Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

2.23 TURBO BOOST PRESSURE SENSOR 2.23.2 Removal of Turbo Boost Sensor Remove the TBS as follows: 1. Disengage the locking tang on the TBS connector body. Grasp the terminal body and gently pull it from the sensor. 2. Remove the two bolts that secure the TBS to the intake manifold. NOTE: Be careful not to lose the O-ring. 3. Remove the TBS from the intake manifold. 2.23.3 Installation of Turbo Boost Sensor Install the Series 60 diesel TBS as follows: NOTE: The TBS is an electronic device. Use care during installation. 1. Apply petroleum jelly to the O-ring. 2. Install O-ring to the TBS. NOTICE: Do not overtighten the bolts that mount the TBS to the intake manifold.

Damage to the TBS may result. Torque the bolts to no more than 2.4 - 3.0 N·m (21 - 26 in·lb). 3. Install the TBS to the intake manifold. 4. Install the two bolts that secure the TBS to the intake manifold. Torque to 2.4-3.0 N·m (21-26 lb·in.). 5. Engage the locking tang on the TBS connector body. Grasp the terminal body and gently pull it towards the sensor. 6. Turn the ignition to the ON position. Observe the DDR for any diagnostic code(s). If any code(s) other than code 25 is logged, refer to the Detroit Diesel Single ECM Troubleshooting Manual (6SE497). (Rev. 2005) All information subject to change without notice. 2-178 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION