SERIES 60 SERVICE MANUAL 2.23 TURBO BOOST PRESSURE SENSOR The Series 60 Diesel Turbo Boost Sensor (TBS) is mounted to the intake manifold with two bolts. A rubber O-ring is used to seal the sensor to the manifold. See Figure 2-113. 1. Intake Manifold 3. Turbo-Boost Pressure Sensor 2. Turbo-Boost Pressure Sensor Bolt 4. O-ring Figure 2-113 Turbo Boost Pressure Sensor NOTE: The DDEC I and DDEC II Turbo Boost Sensors are not identical and must not be mixed up. This device is a pressure sensor that sends an electrical signal to the ECM. The ECM uses this information to compute the amount of air entering the engine. Fuel supply is regulated by the TBS information to control engine smoke.
2.23.1 Replacement of Turbo Boost Sensor The TBS is non-serviceable and must be replaced as an assembly. No adjustment is required. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-177