2.24 AIR INTAKE PRESSURE SENSOR 1. Disengage the locking tang on the AIP sensor connector body. Grasp the terminal body and gently pull it from the sensor. 2. Remove the AIP sensor from the intake manifold. 2.24.3 Installation of Air Intake Pressure Sensor Install the AIP as follows: NOTE: The AIP sensor is an electronic device. Use care during installation. 1. Install the AIP sensor into intake sensor manifold. Torque to 2.4-3.0 N·m (21-26 lb·in.). 2. Engage the locking tang on the AIP connector body. 3. Turn the ignition to the ON position. Observe the DDR for any diagnostic code(s).
If any code(s) other than code 25 is logged, refer to the Detroit Diesel Single ECM Troubleshooting Manual (6SE497). (Rev. 2005) All information subject to change without notice. 2-180 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION