SERIES 60 SERVICE MANUAL 2.25 OIL PRESSURE SENSOR The Oil Pressure Sensor (OPS) is installed into the main engine oil gallery. A typical location is the left rear corner of the cylinder block. See Figure 2-115. Figure 2-115 Engine Oil Pressure Sensor Location The OPS sends an electrical signal to the ECM telling it what the engine oil pressure is at any given speed. A low oil pressure signal exceeding seven seconds is used by the ECM to begin the stop engine or warning function. 2.25.1 Replacement of the Oil Pressure Sensor The OPS is non-serviceable and should be replaced as a unit. No adjustment is required. 2.25.2 Removal of Oil Pressure Sensor Remove the OPS as follows: 1.
Disengage the locking tang on the three-wire connector. Grasp the body of the connector and gently pull it free of the OPS. 2. Use the appropriate wrench on the hex end of the OPS to unscrew it from the engine. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-181