2.25 OIL PRESSURE SENSOR 2.25.3 Installation of Oil Pressure Sensor Install the OPS as follows: NOTE: The OPS is an electronic device. Use care on installation. 1. Place the sensor on the engine and using the appropriate wrench on the hex portion of the sensor tighten it. 2. Use Loctite® Pipe Sealer with Teflon, PT-7260, (or equivalent) on all but the first two threads of the OPS to prevent leaks. 3. Place the connector in the socket and engage the locking tang. 4. Turn the ignition to the ON position. Observe the DDR for any diagnostic code(s). If any code(s) other than code 25 is logged, refer to the Detroit Diesel Single ECM Troubleshooting Manual (6SE497). (Rev.
2005) All information subject to change without notice. 2-182 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION