SERIES 60 SERVICE MANUAL 2.26 OIL TEMPERATURE SENSOR The Oil Temperature Sensor (OTS) is installed into the main engine oil gallery. A typical location is the left rear corner of the cylinder block. See Figure 2-116. The OTS sends an electrical signal to the ECM indicating engine oil temperature. The ECM uses this information to modify engine speed for better cold weather starts and faster warm-ups. Oil temperatures exceeding specification for two seconds or more will begin the stop engine or warning function. NOTE: Series 60G automotive (high pressure fuel system) engines do not have an oil temperature sensor. All DDEC and OEM functions reference coolant temperature.
Figure 2-116 Engine Oil Temperature Sensor Location 2.26.1 Replacement of Oil Temperature Sensor The OTS is non-serviceable, and is replaced as a unit. No adjustment is required. 2.26.2 Removal of Oil Temperature Sensor Removal the OTS as follows: 1. Disengage the locking tang on the two-wire connector. 2. Grasp the body of the connector and gently pull it from the socket. 3. Use the appropriate wrench on the hex portion of the sensor and unscrew it. 2.26.3 Installation of Oil Temperature Sensor Install the OTS as follows: NOTE: The Oil Temperature Sensor is an electronic device. Use care in the installation process. All information subject to change without notice. (Rev.
2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-183