2.28 AIR TEMPERATURE SENSOR FOR HIGH PRESSURE FUEL SYSTEM 2.28 AIR TEMPERATURE SENSOR FOR HIGH PRESSURE FUEL SYSTEM On DDEC III/IV engines there is an Air Temperature Sensor (ATS) mounted to the bottom of the inlet elbow. The ATS sends an electrical signal to the ECM indicating the inlet manifold temperature of the air entering the engine. The ECM uses this information to adjust gas flow, control air fuel ratio and in some cases fan control. The ATS provides necessary input to vary hot idle speed and injection timing resulting in improved cold starts and reduced white smoke. See Figure 2-117. 1. Fuel Temperature Sensor 5. Air Inlet Elbow 2. PSV 6. Low Pressure Regulator 3. Fuel Mixer 7.
Air Temperature Sensor 4. Throttle 8. Fuel Pressure Sensor 9. Fuel Inlet Tee-Fitting Figure 2-119 Fuel Temperature Sensor Series 60G Engine with High Pressure Fuel System The Series 60 natural gas engine air temperature sensor (ATS) is installed into the air inlet tube. The ATS sends an electrical signal to the ECM indicating air inlet temperature. The ECM uses this information to adjust gas flow and control air fuel ratio. (Rev. 2005) All information subject to change without notice. 2-188 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION