2.33 COOLANT LEVEL SENSOR 2.33.4 Removal of Coolant Level Sensor Module Remove the CLS module as follows: 1. Disengage the locking tang on the CLS module connector. Grasp the connector bodies and gently pull them apart. 2. Remove module from vehicle. 2.33.5 Installation of Coolant Level Sensor Module Install the CLS Module as follows: NOTICE: Use care during the installation of the CLS module or damage may occur. 1. Insert the CLS module to the vehicle. 2. Grasp both connector bodies. Gently push them together and engage locking tang on the CLS module connector. (Rev. 2005) All information subject to change without notice. 2-202 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION