2.34 FUEL PRESSURE SENSOR 2.34.1 Replacement of Fuel Pressure Sensor The FPS is non-serviceable and should be replaced as a unit. No adjustment is required. 2.34.2 Removal of Fuel Pressure Sensor Remove the FPS as follows: 1. Disengage the locking tang on the three-wire connector. Grasp the body of the connector and gently pull it free of the FPS. 2. Use the appropriate wrench on the hex end of the FPS to unscrew it from the filter. 2.34.3 Installation of Fuel Pressure Sensor Install the FPS as follows: NOTICE: The FPS is an electrical device. Use care on installation or damage may occur. 1.
Use Loctite® Pipe Sealant with Teflon, PT-7260 (or equivalent) on all but the first two threads of the FPS to prevent leaks. 2. Screw FPS into the filter. 3. Engage locking tang. 4. Turn the ignition to the ON position. Observe the DDR for any diagnostic code(s). If any code(s) other than code 25 is logged, refer to the Detroit Diesel Single ECM Troubleshooting Manual (6SE497). (Rev. 2005) All information subject to change without notice. 2-204 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION