Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 2.35.1 Replacement of Fuel Temperature Sensor The FTS is non-serviceable and should be replaced as a unit. No adjustment is required. 2.35.2 Removal of Fuel Temperature Sensor Remove the FTS as follows: 1. Disengage the locking tang on the two-wire connector. Grasp the body of the connector and gently pull it from the socket. 2. Use the appropriate wrench on the hex portion of the sensor and unscrew it from the fitting. 2.35.3 Installation of Fuel Temperature Sensor Install the FTS as follows: NOTICE: The Fuel Temperature Sensor is an electrical device. Use care in the installation process or damage may occur. 1.

Use Loctite® Pipe sealer with Teflon PT-7260 (or equivalent) on all but the first two threads of the FTS to prevent leaks. 2. Screw the FTS into the fitting or housing. 3. Engage locking tang. 4. Turn the ignition to the ON position. Observe the DDR for any diagnostic code(s). If any code(s) other than code 25 is logged, refer to the Detroit Diesel Single ECM Troubleshooting Manual (6SE497). All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 2-207