Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

2.39 BAROMETRIC PRESSURE SENSOR FOR THE SERIES 60G ENGINE WITH HIGH PRESSURE FUEL SYSTEM 2.39.1 Replacement of the Barometric Pressure Sensor The barometric pressure sensor is non-serviceable and must be replaced as an assembly. 2.39.2 Removal of the Barometric Pressure Sensor Remove the Barometric Pressure Sensor as follows: 1. Disengage the locking tang on the BARO sensor. 2. Disconnect the hose from the inlet of the sensor. 3. Loosen two attaching bolts and remove sensor from bracket. 2.39.3 Installation of the Barometric Pressure Sensor Install the BARO sensor as follows: NOTICE: Use care tightening sensor attaching bolts. Overtightening the bolts will damage the sensor. 1.

Install the sensor on the bracket. Torque bolts to 2.7 N·m (24 lb·in.). 2. Connect the inlet hose. 3. Engage it to the sensor wire harness connector. 4. Turn ignition on and, with Diagnostic Data Reader, clear the AFR (air fuel ratio) learn table. 5. Turn ignition to the "ON" position. Observe or read any diagnostic codes. If any codes other than 25 appears, refer to the DDEC II/IV Troubleshooting Guide, 6SE497. (Rev. 2005) All information subject to change without notice. 2-216 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION