14 400 Series Wiring diagram - automatic shutdown 15 amp alternator - 403C-11 Automatic shutdown operation conditions If the conditions below last for more than 10 seconds during the start operation, the engine will shut down. If the conditions below last for more than 2 seconds while the engine is operated, the engine will shut down. Warning! There is no protection against low water levels. Conditions Water temperature switch: If the water temperature exceeds 105 °C ± 4 °C. Oil Pressure Switch: If the oil pressure falls below 0,3 kgf/cmІ (4.27 lbf/inІ).
1 Alternator warning lamp 9 Thermostat switch 2 Regulator 10 Fuse 3 Alternator 4 Battery 11 Key switch 12 Glow signal 5 Starter motor 13 Glow plugs 6 Oil pressure warning lamp 7 Oil pressure switch (1) 14 Solenoid switch 8 Water temperature warning lamp 15 Automatic shutdown device 16 A delayed fuse can be fitted if desired (1) Max current draw for standard oil pressure switch is 0.42 amps (5 Watt lamp max). = Diode. Capacity: Current 3 amp. Reverse Voltage: 600V. (This is mandatory) . 3 4 6 15 1 6 8 14 Sb G 13 2 3 Y 7 9 R Sb B 10 AC 17 30 50 19 B 16 12 S 4 5 11 112 Workshop Manual, TPD 1458E, issue 3 - Perkins Confidential: Green 5 1 2