400 Series 14 Wiring diagram - automatic shutdown 40 amp alternator - 403C-11 Automatic shutdown operation symptoms If the conditions below last for more than 10 seconds during the start operation, the engine will shut down. If the conditions below last for more than 2 seconds while the engine is operated, the engine will shut down. Warning! There is no protection against low water levels. Conditions Water temperature switch: If the water temperature exceeds 105 °C ± 4 °C. Oil Pressure Switch: If the oil pressure falls below 0,3 kgf/cmІ (4.27 lbf/inІ).
1 Alternator warning lamp 9 Key switch 2 Alternator 10 Glow signal 3 Battery 4 Starter motor 11 Glow plugs 12 Fuse 5 Oil pressure warning lamp 13 Fuse 6 Oil pressure switch (1) 14 Solenoid switch 7 Water temperature warning lamp 8 Thermostat switch 15 Automatic shutdown device 16 A delayed fuse can be fitted if desired (1) Max current draw for standard oil pressure switch is 0.42 amps (5 Watt lamp max). = Diode. Capacity: Current 3 amp. Reverse Voltage: 600V. (This is mandatory) . 15 1 5 7 14 2 11 N 6 8 F B 13 B 16 12 AC 17 30 50 19 10 3 4 S 9 Workshop Manual, TPD 1458E, issue 3 - Perkins Confidential: Green 113 6 4 5 1 2 3