Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE When 99.4 6 CAUTION 4 - 18 NOTICE The inner element must not b e used again even after cleaning. W replacing the outer element, re place the inner element at the same tim 6. Direct dry compressed air (Max. 0.69 MPa (7 kg/cm2, PSI)) from the inside of t direct the compressed a again from the inside. 1) Replace any outer times or used for 1 y same time. 2) Even if the outer el indicator (1) enters elements. 7. If small holes or thinner he outer element along its folds. T ir from the outside along the folds, element which has been cleane ear.

Replace the inner element at it is checked by shining a light through it after cleaning, repl the element. NOTICE When cleaning the element, do not hit or beat it against anything. Do not use an element whose folds, gasket or seal are damaged. a light through it after cleaning, repl dust the red position (7.5 kPa) immedia tely after cleaning, replace b oth the inner and outer When installing the cover (3), c heck O-ring (7) and replace it if there a 8. Set the cleaned outer e lement in position, then secure co ver (3) with mounting clips (2 9. Press the dust indicator button to return the yellow piston t original position. 10. Close the engine side c over on the right side of the machi ne.

After cleaning, if the air c line (7.5 kPa), replace t leaner clogging caution lamp light s up immediately or the yello w piston reaches th e red he inner and outer elements.