Refill Capacities Fluid Recommendations 44 SEBU9064 Maintenance intervals for engines that use biodiesel – The oil change interval can be adversely affected by the use of biodiesel. Use oil analysis in order to monitor the condition of the engine oil. Use oil analysis also in order to determine the oil change interval that is optimum. Aftermarket Oil Additives Perkins does not recommend the use of aftermarket additives in oil. It is not necessary to use aftermarket additives in order to achieve the engines maximum service life or rated performance. Fully formulated, finished oils consist of base oils and of commercial additive packages.
These additive packages are blended into the base oils at precise percentages in order to help provide finished oils with performance characteristics that meet industry standards. Note: These engine oils are not approved by Perkins and these engine oils must not be used: CC, CD, CD-2, CF-4, CG-4, CH-4 and CI-4. Lubricant Viscosity Recommendations There are no industry standard tests that evaluate the performance or the compatibility of aftermarket additives in finished oil. Aftermarket additives may not be compatible with the finished oils additive package, which could lower the performance of the finished oil. The aftermarket additive could fail to mix with the finished oil.
This failure could produce sludge in the crankcase. Perkins discourages the use of aftermarket additives in finished oils. The correct SAE viscosity grade of oil is determined by the minimum ambient temperature during cold engine start-up, and the maximum ambient temperature during engine operation. Refer to illustration 22 (minimum temperature) in order to determine the required oil viscosity for starting a cold engine. To achieve the best performance from a Perkins engine, conform to the following guidelines: Refer to illustration 22 (maximum temperature) in order to select the oil viscosity for engine operation at the highest ambient temperature that is anticipated.
See the appropriate “Lubricant Viscosities”. Refer to the illustration 22 in order to find the correct oil viscosity grade for your engine. Generally, use the highest oil viscosity that is available to meet the requirement for the temperature at start-up. At the specified interval, service the engine. Use new oil and install a new oil filter. Perform maintenance at the intervals that are specified in the Operation and Maintenance Manual, “Maintenance Interval Schedule”. Oil analysis Some engines may be equipped with an oil sampling valve. If oil analysis is required, the oil sampling valve is used to obtain samples of the engine oil.
The oil analysis will complement the preventive maintenance program. The oil analysis is a diagnostic tool that is used to determine oil performance and component wear rates. Contamination can be identified and measured by using oil analysis. The oil analysis includes the following tests: Illustration 22 g02932046 Lubricant Viscosities Supplemental heat is recommended for cold soaked starts below the minimum ambient temperature. Supplemental heat may be required for cold soaked starts that are above the minimum temperature that is stated, depending on the parasitic load and other factors. Cold soaked starts occur when the engine has not been operated for a period of time.
This interval will allow the oil to become more viscous due to cooler ambient temperatures.