SEBU9064 45 Refill Capacities Fluid Recommendations The Wear Rate Analysis monitors the wear of the engines metals. The amount of wear metal and type of wear metal that is in the oil is analyzed. The increase in the rate of engine wear metal in the oil is as important as the quantity of engine wear metal in the oil. NOTICE These recommendations are subject to change with- out notice. Contact your local Perkins distributor for the most up-to-date recommendations. Tests are conducted in order to detect contamination of the oil by water, glycol, or fuel. The fuel information within this OMM is for use with the following engine models:
402F-05, 403F-07, 403F-11, and 403F-15 The Oil Condition Analysis determines the loss of the oils lubricating properties. An infrared analysis is used to compare the properties of new oil to the properties of the used oil sample. This analysis allows technicians to determine the amount of deterioration of the oil during use. This analysis also allows technicians to verify the performance of the oil according to the specification during the entire oil change interval. Diesel Fuel Requirements Perkins is not in a position to continuously evaluate and monitor all worldwide distillate diesel fuel specifications that are published by governments and technological societies.
The Perkins table for Specification for Distillate Diesel Fuel provides a known reliable baseline in order to judge the expected performance of distillate diesel fuels that are derived from conventional sources. i05341022 Fluid Recommendations Satisfactory engine performance is dependent on the use of a good quality fuel. The use of a good quality fuel will give the following results: long engine life and acceptable exhaust emissions levels . The fuel must meet the minimum requirements that are stated in the table 25 . Glossary ISO International Standards Organization NOTICE The footnotes are of the key part Perkins Specifica- tion for Distillate Diesel Fuel Table. Read ALL of the footnotes.
ASTMAmerican Society for Testing and Materials HFRRHigh Frequency Reciprocating Rig for Lubricity testing of diesel fuels FAMEFatty Acid Methyl Esters CFRCo-ordinating Fuel Research ULSDUltra Low Sulfur Diesel RMERape Methyl Ester SMESoy Methyl Ester EPA Environmental Protection Agency of the United States PPM Parts Per Million General Information NOTICE Every attempt is made to provide accurate, up-to-date information. By use of this document you agree that Perkins Engines Company Limited is not responsible for errors or omissions.