SEBU9064 75 Maintenance Recommendations Fuel System Primary Filter/Water Separator - Drain i02627223 Fuel System Primary Filter/ Water Separator - Drain Fuel leaked or spilled onto hot surfaces or electri- cal components can cause a fire. To help prevent possible injury, turn the start switch off when changing fuel filters or water separator elements. Clean up fuel spills immediately. NOTICE The water separator is not a filter. The water separa- tor separates water from the fuel. The engine should never be allowed to run with the water separator more than half full. Engine damage may result. Illustration 46 g03381282 Typical example 1.
Install a new filter element (2) to the fuel filter base (1). 2. Lubricate the O ring seal (3) with clean engine oil. Do NOT fill the bowl with fuel before the assembly is installed. 3. Install the filter bowl (4) to the fuel filter base (1). Tighten the filter bowl (4) by hand. Illustration 47 g01316965 Typical example 4. The secondary fuel filter must be replaced at the same time as the primary fuel filter. Refer to the Operation and Maintenance Manual, “Fuel System Secondary Filter - Replace”. 1. Open drain (1). Catch the draining fluid in a suitable container. Dispose of the drained fluid correctly. 2. Close drain (1).
NOTICE The water separator is under suction during normal engine operation. Ensure that the drain valve is tight- ened securely to help prevent air from entering the fuel system.