76 SEBU9064 Maintenance Recommendations Fuel System Secondary Filter - Replace i05337334 Fuel System Secondary Filter - Replace Fuel leaked or spilled onto hot surfaces or electri- cal components can cause a fire. To help prevent possible injury, turn the start switch off when changing fuel filters or water separator elements. Clean up fuel spills immediately. NOTICE Do not allow dirt to enter the fuel system. Thoroughly clean the area around a fuel system component that will be disconnected. Fit a suitable cover over discon- nected fuel system component.
Illustration 48 g03317866 Typical example NOTICE Care must be taken to ensure that fluids are con- tained during performance of inspection, mainte- nance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. 2. Clean the outside of the fuel filter assembly (1). 3. Remove setscrew (2). 4. Remove the canister (3). Ensure that any fluid is drained into a suitable container. Dispose of all fluids according to local regulations and mandates. Note: The primary filter element must be replaced at the same time as the secondary filter element.
Refer to Operation and Maintenance Manual, “Fuel System Primary Filter (Water Separator) Element - Replace”. Fuel Filter with Canister 1. Close the fuel supply valve. Illustration 49 g02710378 Typical example 5. Assemble the following items: seals (8), seal (7), canister (3) and bowl (10). Place washer (5) and seal (6) on setscrew (2).