FUNCTION BRAKE FUNCTION BRAKE 3) 3) 101 212 213 202 RF 204 215 216 71 500 Counter balance spool CB Reducing valve 500 D P 1 Position 1 HIGH Position 2 A B LOW Position 3 P 2 P Brake room Orifice B 71 The brake is released by applying to the brake piston the pressure led through the built in counterbalance spool subassembly. With no pressure working , the brake force is always ensured. Brake force is generated from friction plate (215) which is combined with cylinder block (204) as spline, separate plate (216) which is embedded in spindle (101), spindle (101), parking piston (212).
Without pressure being applied to the brake piston, the brake piston is pushed by fourteen brake spring (213), and the friction plate and separation plate are held between the brake and spindle. This holding force functions as the friction force. This friction force restrains the shaft (202) spline coupled with the cylinder block, and this function is the brake. 4809S2TM05 N ormal travelling ormal travelling (at position 1 or 3) During normal travelling, the pressured oil coming through the counter balance spool is applied to the brake room to release brake, after was decompressed at a reducing valve.
At this time, the slight hydraulic oil is drained through the orifice B (71), but the pressure at brake room releases the braking by overcoming the spring force. Cause the pressure at brake room is always applied from the counter balance valve. N eutral eutral (at position 2) The brake room's pressure is decreased by the blocked oil-passage, and the brake is generated by being that the brake spring force is much than the brake room's pressure. At this time, the hydraulic oil in the brake room is drained through the orifice B (71), then the spool returns to the neutral position.
When the condition changes from travelling to stop, the brake runs in order of precedence after stopping motor, so it is preventing the damage of friction plate. 2-75 B