hyundai R510LC-7 — 4. TRAVEL DEVICE

4) 4) RELEASING METHOD OF BRAKE RELEASING METHOD OF BRAKE In releasing the brake without applying the brake releasing pressure, follow the procedures shown below. ц Even with the negative brake released, the hydraulic motor will not run. Even with the negative brake released, the hydraulic motor will not run.

When it is difficult to generate the working pressure due to failure of the pump or so, and the whole When it is difficult to generate the working pressure due to failure of the pump or so, and the whole machine is to be pulled for transportation without removing the hydraulic motor, connect pressure machine is to be pulled for transportation without removing the hydraulic motor, connect pressure measurement ports Am, Bm with a short hose or something. measurement ports Am, Bm with a short hose or something. Then the machine can be pulled slowly. Then the machine can be pulled slowly. 45 RF 4809S2TM08 2-76 Details of work Tools Remove two plugs (45) from the rear flange (RF).

(For their position, see the attached installation dimension.) Insert in there, tighten an M10 screw of 135 mm in length into a tapped hole of the brake piston. Then the condition having the brake released pressure is attained and the brake release pressure is attained and the brake is released. Socket Wrench 6 mm 8 mm