hyundai R510LC-7 — 3. AUTOMATIC DECELERATION SYSTE

GROUP 3 AUTOMATIC DECELERATION SYSTEM Engine Work equipment pressure switch Travel oil pressure switch CAN + Main control valve Pressure switch signal Auto decel switch signal Pressure switch signal MCU Accel dial signal Normal CN-92 Emergency Accel dial 51075MS04 1. WHEN AUTO DECEL LAMP ON If all the work equipment control levers including swing and travel levers are at neutral for at least 4 seconds, MCU transmits the throttle command to ECM to reduce the engine speed to 1000 rpm . As the result of reducing the engine speed, fuel consumption and noise are effectively cut down during non-operation of the control levers.

When the Auto decel lamp is turned off by pressing the switch or any control lever is operated, the reduced engine speed rises upto the speed set before deceleration in a second. 45075MS05 2. WHEN AUTO DECEL LAMP OFF The engine speed can be set as desired using the engine speed switch, and even if the control levers are neutral, the engine speed is not reduced. Auto decel function can be activated when accel dial position is over 4. 5-6 ECM CAN- GND