hyundai R510LC-7 — 3. ELECTRICAL SYSTEM

9. WHEN FUEL GAUGE DOES NOT OPERATE (Check warning lamp ON/OFF) Before disconnecting the connector, always turn the starting switch OFF. Before carrying out below procedure, check all the related connectors are properly inserted. After checking, insert the disconnected connectors again immediately unless otherwise specified. 2nd~10th step Check Table 1 st step 11th~12th step CONTROLLER FUEL SENDER 24 CD-2 31 CN-51 29076ES06 6-32 YES Is resistance YES between CN-51 (24) and (31) over 1k ? YES Starting switch : OFF Check resistance Does the gauge Disconnect CN-51 between CD-2(1) light up and NO and (2) down at lamp NO check? Disconnect CD-2 See Table Starting switch :

ON NO Cause Remedy Disconnection in wiring harness Defective controller Defective fuel sensor Defective cluster Check and repair Replace Replace Replace Level Item White range Green range Red range Unit Resistance( ) 700~601 600~101 ~100 Tolerance(%) 5 5 5 1 2