hyundai R510LC-7 — 3. ELECTRICAL SYSTEM

Starting switch : START Check operation of start motor 12. WHEN ENGINE DOES NOT START After checking, insert the disconnected connectors again immediately unless otherwise specified. Before carrying out below procedure, check all the related connectors are properly inserted. Before disconnecting the connector, always turn the starting switch OFF. 23 NO YES Check voltage YES Defective magnet Defective battery Cause Remedy Replace Check engine system charge or replace(After checking specific gravity of battery) 6-35 1 2 CS-74 50076ES07 YES Check operation YES Check voltage of start motor YES between starter magnet coil and Starting switch : START chassis NO Starting switch :

START YES Check operation SPEC : 20~30V Check voltage of start relay CR- YES between NO 23 CR-5 (30) and chassis Starting switch : START Starting switch :START Check operation SPEC : 20~30V of start safety NO relay CR-5 YES Starting switch : ON Check voltage between NO CR-5 (86) and chassis NO Starting switch : ON Voltage : 20~30V YES Check voltage between CR-23 and chassis NO Starting switch : ON Voltage :

20~30V Cause Remedy Defective battery Defective magnet of start motor Defective start relay Defective start safety relay Defective relay Disconnection in wiring harness or poor contact between CR-5(86) and CS-2(5) Defective start relay Disconnection in wiring harness or poor contact between CR-5(87)- Check engine system charge or replace(After checking specific gravity of battery) Replace Replace Repair or replace (After clean) Replace Repair or replace (After clean) Replace Repair or replace (After clean)