honda — Maintenance

17) Holding the cutout in the crankshaft pulley aligned with the ” mark on the chain case, check that the “ ” mark on the intake camshaft sprocket is in alignment with the ” mark on the exhaust camshaft sprocket. (The No.1 piston is at the top dead center of its compression stroke this time.) [1] EXHAUST CAMSHAFT SPROCKET [2] “ ” MARKS [3] INTAKE CAMSHAFT SPROCKET Perform this check on each cylinder with its piston at the top dead center of its compression stroke (i.e. both the intake and exhaust rocker arms are not lifted).

18) With the engine in the position described in step 17, check the intake and exhaust valve clearances on the No.1 cylinder by inserting a feeler gauge between the intake/exhaust side rocker arm valve adjusting screw and the valve stem end. [1] VALVE ADJUSTING LOCK NUT [2] VALVE ADJUSTING SCREW [6] INTAKE SIDE [5] EXHAUST SIDE No.1 No.1 No.2 No.2 No.3 No.3 No.4 No.4 [3] FEELER GAUGE 19) If adjustment is necessary, loosen the valve adjusting lock nut while holding the valve adjusting screw with a screwdriver. 20) Insert a feeler gauge between the intake/exhaust side rocker arm valve adjusting screw and the valve stem end.

21) Adjust the intake and exhaust valve clearances by turning the valve adjusting screw. 22) After adjustment, secure the valve adjusting screw and loosely tighten the lock nut. 23) Recheck the valve clearances again. Tighten the valve adjusting lock nut to the specified torque. TORQUE: Intake side: 20 N . m (2.0 kgf . m, 14 lbf . ft) Exhaust side: 14 N . m (1.4 kgf . m, 10 lbf . ft) [3] FEELER GAUGE [4] SCREWDRIVER 3-13 I Valve clearance E 0.21 – 0.25 mm N (0.008 – 0.010 in) 0.28 – 0.32 mm X (0.011 – 0.013 in)