honda — Maintenance

25) After adjusting the valve clearances on each cylinder, install the silencer duct assembly on the silencer case. [1] SILENCER DUCT ASSEMBLY 6 x 25 (4) 26) Set the four 6 x 25 mm flange bolts and the four 6 mm washers, then tighten the four 6 x 25 mm flange bolts securely. [2] 6 mm WASHER (4) 27) Set the breather tube in the guide of the silencer duct assembly and secure the tube with the 18.5 mm clamp. [1] SILENCER DUCT ASSEMBLY [2] 18.5 mm CLAMP 28) Secure the pressure regulator control tube with the two 3.5 mm tube clips of the silencer duct assembly. Connect the pressure regulator control tube aligning the marked part on the tube with the end of the 3.5 mm tube clip (P. 2-70).

29) Set the main wire harness’ harness band clip on the silencer duct assembly. [6] GUIDE 30) Install the cylinder head cover (P. 10-40). [5] 3.5 mm TUBE CLIP (2) [4] HARNESS BAND CLIP [3] PRESSURE REGULATOR CONTROL TUBE 7. FUEL STRAINER (LOW PRESSURE SIDE) [1] FUEL STRAINER (LOW PRESSURE SIDE) Inspection: 1) Remove the engine cover (P. 4-2). 2) Visually check the fuel strainer cup (low pressure side) for water or foreign material in the cup. Check the fuel strainer for contamination. 3) If there is water or foreign material in the fuel strainer cup, or if the fuel strainer is contaminated, disassemble the strainer and clean it (P. 3-16). 3-15