honda — Maintenance

8. FUEL STRAINER (HIGH PRESSURE SIDE) Disconnect the battery cable from the battery negative (-) terminal before relieving the fuel pressure. Replace the sealing washers when the service check bolt is loosened or removed. Catch the draining gasoline from the filter to avoid contaminating the engine parts with the gasoline. WARNING Gasoline is highly flammable and explosive. You can be burned or seriously injured when handling fuel. • Keep heat, sparks and flame away. • Handle fuel only outdoors. • Wipe up spills immediately. Replace the fuel filter (high pressure side) at the replacement interval shown or in the following case.

Regular replacement period of every 2 years or 400 operating hours When the fuel pressure does mot reach 270 – 320 kPa (2.8 – 3.3 kgf/cm 2 , 40 – 47 psi) with the pressure regulator control tube connected, be sure that the fuel pump unit (P. 5-107) and the pressure regulator (P. 5-106) are normal, and replace the fuel filter (high pressure side). Replacement: 1) Remove the engine cover (P. 4-2). Remove the L./R. engine under covers (P. 4-9). [1] STRAINER 2) Relieve the fuel pressure following the instruction of “How to relieve fuel pressure” (P. 5-102). 3) Remove the three screw-washers from the strainer cover while wrapping the strainer cover with a cloth or shop towel.

Replace the O-ring on assembly. 4) Remove the strainer. Replace the fuel strainer if it is contaminated or damaged. Assembly: 1) Apply the engine oil to a new O-ring and install it on the strainer cover. [8] 5 mm SCREW- WASHER (3) [2] SPRING 2) Install the spring, strainer and washer in the case, then install the strainer cover. 3) Tighten the three screw-washers to the specified torque. [3] WASHER TORQUE: 3.4 N . m (0.35 kgf . m, 2.5 lbf . ft) 4) After tightening the screw-washers, check for gasoline leakage. [4] O-RING 5) Set a new sealing washer on the service check bolt, and tighten the service check bolt to the specified torque. TORQUE: 12 N . m (1.2 kgf . m, 9 lbf .

ft) [7] SERVICE CHECK BOLT [5] STRAINER COVER 6) Install the L./R. engine under covers (P. 4-14). Install the engine cover (P. 4-2). [6] SEALING WASHER 3-18