honda — Maintenance

9. WATER SEPARATOR with WATER LEVEL SENSOR [1] WATER SEPARATOR WARNING Gasoline is highly flammable and explosive. You can be burned or seriously injured when handling fuel. • Keep heat, sparks and flame away. • Handle fuel only outdoors. • Wipe up spills immediately. Inspection: 1) Remove the engine cover (P. 4-2). [2] HARNESS CLIP [1] CONNECTOR BRACKET A 2) Check the water separator for water accumulation or sediment. If water or sediment is found, or the water filled alert buzzer is sound, remove the water separator as follows. Removal/Cleaning:

[3] WATER LEVEL SENSOR 2P CONNECTOR Turn the ignition switch to the OFF position, disconnect the battery negative (-) cable, then positive (+) cable. 1) Open the harness clip. Remove the water level sensor 2P connector from the connector bracket A. Disconnect the water level sensor 2P connector. [2] FUEL TUBE C 2) Clamp the fuel tube A and C with the commercially available tube clips securely. [1] FUEL TUBE A [3] TUBE CLIPS (Commercially available) [4] WATER SEPARATOR 3) Remove the strainer suspension from the fuel strainer stay. [1] FUEL STRAINER STAY 4) Disconnect the fuel tube A and C from the water separator with water level sensor.

Before disconnecting the fuel tubes, be sure to clamp the fuel tubes with a tube clips to prevent the gasoline from leaking. Remove the strainer suspension from the water separator cup. [2] STRAINER SUSPENSION 3-19