honda — Maintenance

Disassembly: [1] 5 x 12 mm SCREW (3) 1) Remove the three 5 x 12 mm screws from the water separator body, then remove the plate and the water separator cup. 2) Clean the water separator cup. Replace the fuel strainer with a new one if it is contaminated. Replace the O-ring with a new one on assembly. [2] PLATE [3] WATER SEPARATOR CUP [4] O-RING [5] WATER SEPARATOR BODY Water level sensor float check: 1) Check the float in the water separator cup for smooth operation. 2) If it does not operate smoothly, replace the water separator cup. Water level sensor continuity check: 1) With the water separator cup removed, hold the cup upright (i.e.

as if it is mounted) and check for continuity between the 2P connecter terminals. There must be no continuity between the terminals. 2) With the water separator cup removed, hold the cup upside down and check for continuity between the 2P connector terminals. There must be continuity between the terminals. [1] FLOAT 3) If there is any abnormality during the check, replace the water separator cup. Assembly: 1) Set a new O-ring on the water separator cup. Install the water separator cup and the plate on the water separator body. 2) Tighten the three 5 x 12 mm screws to the specified torque. [2] NORMAL (AS INSTALLED) [3] UPSIDE DOWN (INVERTED CUP) TORQUE: 3.4 N . m (0.35 kgf . m, 2.5 lbf .

ft) 3-20