honda — Engine Cover/Cover Lock

g. ADJUSTMENT • HOOK BRACKET 1) Install the engine cover on the outboard motor and lock it securely. 2) Measure the clearance between the engine cover and the L./R. engine under covers. Measure the clearance at the three points, i.e. at the front and at the rear right and left sides. 3) Check that the measurement is within 17.5 – 18.5 mm (0.69 – 0.73 in) at each point. 4) If the measurement is out of the specification, adjust the clearance. 17.5 – 18.5 mm (0.69 – 0.73 in) 5) To adjust, remove the engine cover and set a wrench or equivalent tool in the cutout in the tapered part of the cover lock bolt. Loosen the 6 mm hex. nut of the hook bracket assembly.

[1] Set a wrench or equivalent tool at tapered part. 6) After assembly, loosely tighten the 6 mm hex. nut. 7) Install the engine cover on the outboard motor and lock it securely. Measure the clearance between the engine cover and the L./R. engine under covers again. If the clearance is out of the specification, repeat step 5. If the clearance is within the specification, remove the engine cover and tighten the 6 mm hex. nut securely. 8) Install the engine cover (P. 4-2). [2] 6 mm HEX. NUT 4-5