honda — Engine Cover/Cover Lock

2. FRONT SEPARATE COVER a. REMOVAL 1) Remove the engine cover (P. 4-2). 2) Loosen the undercase grommet band and remove it from the remote control cable grommet. 3) Remove the 6 x 17 mm special bolt and the three 6 x 25 mm screws, then detach the front separate cover. 4) Remove the front separate cover. [2] UNDERCASE GROMMET BAND [3] 6 x 17 mm SPECIAL BOLT [1] FRONT SEPARATE COVER [4] 6 x 25 mm SCREW (3) b. INSTALLATION 1) Install the front separate cover by aligning the recess at the rear of the front separate cover (i.e. R. engine under cover side) with the projection of the R. engine under cover. 2) Install by aligning the projection at the front (i.e.

under cover front bracket side) of the front separate cover with the recess of the under cover front bracket. 4-7 [1] [2] RECESS [5] PROJECTION [4] [3] R. ENGINE FRONT UNDER SEPARATE COVER COVER [2] RECESS [7] [6] UNDER COVER [5] FRONT BRACKET PROJECTION [3] FRONT SEPARATE COVER FRONT BRA OJECTION ] ONT SEPARATE OVER 3 FR C [2] RECES [3] FRONT SEPARATE COVER 2] RECES S