3. L./R. ENGINE UNDER COVERS a. REMOVAL Remove the following parts. – Engine cover (P. 4-2) – Front separate cover (P. 4-7) – Electric part cover (P. 3-22) [1] FLUSH PLUG CAP 1) Remove the flush plug cap from the R. engine under cover. 2) Open the wire harness clip. Remove the power tilt switch 3P connector from the connector bracket B. [1] CONNECTOR BRACKET B 3) Disconnect the power tilt switch 3P connector. [3] WIRE HARNESS CLIP [2] POWER TILT SWITCH 3P CONNECTOR 4) Set a screwdriver in the slot in each mud guard clip as shown and raise the mud guard clips. Remove the six mud guard clips. 5) Remove the under cover grommet.
[2] SLOT [4] MUD GUARD CLIP (6) [5] UNDER COVER GROMMET 4-9 [1] SCREWDRIVER