19) Push in the head of the mud guard clips in the numbered sequence securely. [1] LIP on the reverse side of the grommet. 20) Check that the lip on the reverse side of the under cover grommet is set on the engine under cover. ⑤ ⑥ Check that the under cover grommet adheres to the engine under cover securely. ① ② ③ ④ 21) Connect the power tilt switch 3P connector. [2] ALTERNATOR FUSE CABLE [3] CONNECTOR BRACKET B 22) Install the power tilt switch 3P connector on the connector bracket B. [1] PGM-FI MAIN RELAY WIRE Clamp the alternator fuse cable, PGM-FI main relay wire and the power tilt switch wire with the wire harness clip.
[6] WIRE HARNESS CLIP [5] POWER TILT SWITCH WIRE [4] POWER TILT SWITCH 3P CONNECTOR 23) Tighten the flush plug cap on the R. engine under cover. 24) Install the following parts. – Electric part cover (P. 3-22) – Front separate cover (P. 4-7) – Engine cover (P. 4-2) [1] FLUSH PLUG CAP 4-19