4. UNDER COVER FRONT BRACKET/ L./R. SIDE COVER BRACKETS [1] 4 x 7 x 160 mm VINYL TUBE [2] COVER LOCK CABLE A [3] LOCK NUT Remove the following pars. – Engine cover (P. 4-2) – Front separate cover (P. 4-7) – L./R. engine under cover (P. 4-9) – Remote control cable/grommet (P. 17-2) a. UNDER COVER FRONT BRACKET REMOVAL: [6] FRONT LOCK 1) Remove the 4 x 7 x 160 mm vinyl tube and the 3.5 x 430 mm fuel tube from the under cover front bracket. [5] UNDER COVER FRONT BRACKET [4] 3.5 x 430 mm FUEL TUBE 2) Loosen the cover lock cable A lock nut and remove the cover lock cable A from the front lock.
3) Remove the trim angle sensor 3P connector and the power tilt motor 2P connector from the connector bracket A. [1] POWER TILT MOTOR 2P CONNECTOR [2] TRIM ANGLE SENSOR 3P CONNECTOR Disconnect the trim angle sensor 3P connector and the power tilt motor 2P connector. [3] CONNECTOR BRACKET A 4) Remove the undercase grommet C outside from the under cover front bracket. [1] WIRES [2] TUBE Pull out the tube and wires through the hole in the under cover front bracket. [5] HOLE [3] UNDER COVER FRONT BRACKET [4] UNDERCASE GROMMET C 4-20