BF135A•BF150A 5. MIL power line check -1. Turn the ignition switch OFF and disconnect the fuse box 3P connector. -2. Turn the ignition switch ON. Measure the voltage between the No. 2 (Yellow/Red) terminal of the fuse box side 3P connector and the engine ground 6. Alternator indicator light check -1. Turn the ignition switch ON and check the alternator indicator light. Does the alternator indicator light come ON? YES – Perform “8. Function test”. NO – Replace the MIL. FUSE BOX SIDE 3P CONNECTOR 7. MIL line check -1. Turn the ignition switch OFF and disconnect the ECM connector B. -2. Disconnect the MIL 6P connector. -3. Check for continuity between the No.
25 (Red/Blue) terminal of the ECM harness side connector B and the No. 4 (Red/Blue) terminal of the MIL harness side 6P connector. YELLOW/RED VIEWED FROM THE TERMINAL SIDE Is there the battery voltage? YES – Go to the step 3. NO – The PGM-FI main relay is faulty. MIL HARNESS SIDE 6P CONNECTOR ECM CONNECTOR B WARNL (RED/BLUE) -3. Turn the ignition switch OFF and connect the fuse box 3P connector. -4. Disconnect the MIL 6P connector. -5. Turn the ignition switch ON. Measure the voltage between the No. 6 (Yellow/Black) terminal of the MIL 6P harness side connector and the engine ground. VIEWED FROM THE TERMINAL SIDE MIL HARNESS SIDE 6P CONNECTOR Is there the continuity? YES – Go to the step 4.
NO – Repair open in the main harness. YELLOW/BLACK -4. Check for continuity between the No. 4 (Yellow/ Black) terminal and the No. 6 (Red/Blue) terminal of the MIL 6P connector. VIEWED FROM THE TERMINAL SIDE MIL 6P CONNECTOR YELLOW/BLACK RED/BLUE Is there the battery voltage? YES – Perform “6. Alternator indicator light check”. NO – Repair open in the main wire harness. VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Substitute a known-good ECM and recheck. NO – MIL is faulty or open circuit in the MIL harness wire. 5-20