BF135A•BF150A 8. Function test -1. Turn the ignition switch OFF and connect the HDS pocket tester. -2. Turn the ignition switch ON and perform the function test.(See the HDS pocket tester's operation manual for the test procedure.) MIL Comes ON but DTC Code Does Not Appear 1. ECM power line check -1. Turn the ignition switch OFF and disconnect the ECM connector C. -2. Turn the ignition switch ON. Measure the voltage between the respective terminals of the No. 2 (Yellow/Black) and No. 6 (Yellow/Black) terminals of the ECM connector C and the engine ground. Does the MIL blink? YES – Substitute a known-good ECM and recheck. NO – Check the MIL.
If the MIL is normal, repair the main wire har- ness (open in the Red/Blue wire between the MIL and ECM). ECM CONNECTOR C IGP2 (YELLOW/BLACK) IGP1 (YELLOW/BLACK) VIEWED FROM THE TERMINAL SIDE Is there the battery voltage? YES – Perform “2. Data link connector check”. NO – Repair open in the main harness. 2. Data link connector check -1. Turn the ignition switch OFF and disconnect the HDS pocket tester. -2. Turn the ignition switch ON. Measure the voltage between the No. 4 (Yellow/Red) terminal of the data link connector and the engine ground. DATA LINK CONNECTOR YELLOW/RED VIEWED FROM THE TERMINAL SIDE Is there the battery voltage? YES – Go to the step 3.
NO – Repair open in the main harness. 5-21