honda — Programmed Fuel Injection

BF135A•BF150A -3. Turn the ignition switch OFF and disconnect the ECM connector B. -4. Check for the continuity between the No. 3 (Light green/White) terminal of the data link connector and the engine ground. Is there the continuity? YES – Perform “3. DTC recheck”. NO – Repair open in the main harness. 3. DTC recheck -1. Turn the ignition switch OFF and connect the HDS pocket tester. -2. Turn the ignition switch ON and check the DTC with the HDS pocket tester. DATA LINK CONNECTOR LIGHT GREEN/WHITE Is the main code 0 (either of 0-2, 0-5 or 0-8)? YES – Substitute a known-good ECM and recheck. NO – Troubleshoot the problem of the DTC. VIEWED FROM THE TERMINAL SIDE Is there the continuity?

YES – Repair short in the main harness. NO – Go to the step 5. -5. Check for the continuity between the No. 3 (Light green/White) terminal of the data link connector and the No. 16 (Light green/White) terminal of the ECM harness side connector B. ECM CONNECTOR B DATA LINK CONNECTOR SCS (LIGHT GREEN/ WHITE) VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Go to the step 6. NO – Repair open in the main harness. -6. Check for the continuity between the service check connector No. 1 (Black) terminal and the engine ground. DATA LINK CONNECTOR GND (BLACK) VIEWED FROM THE TERMINAL SIDE 5-22