honda — Programmed Fuel Injection

BF135A•BF150A Alert System Initial Operation Is Faulty 2. Buzzer line check -1. Turn the ignition switch OFF and disconnect the Yellow/Green terminal from the buzzer. -2. Connect the Yellow/Green terminal of the buzzer to the Black terminal with a jumper wire to short. -3. Turn the ignition switch ON and check that the buzzer sounds. 1. Function test -1. Turn the ignition switch OFF and connect the HDS pocket tester. -2. Turn the ignition switch ON and test the buzzer using the HDS pocket tester. Does the buzzer sound? YES – Repair open in the wire harness (wire between the buzzer and ECM). NO – Go to the step 4. Does the buzzer sound? YES – Go to the step 3. NO – Perform “2.

Buzzer line check”. -3. Test the MIL using the HDS pocket tester. -4. Perform the unit check of the buzzer. Does the MIL blink? YES – Go to the step 4. NO – Perform “3. MIL line check”. Is the buzzer normal? YES – Go to the step 5. NO – The buzzer is faulty. -4. Test the overheat indicator light using the HDS pocket tester. -5. Perform the unit check of the ignition switch (P. 16-9). Is the ignition switch normal? YES – Go to the step 6. NO – The ignition switch is faulty. Does the overheat indicator light blink? YES – Go to the step 5. NO – Perform “4. Overheat indicator line check”. -6. Disconnect the remote control box harness side 14P connector. -7. Turn the ignition switch ON.

Check for the continuity between the No. 1 (White/Black) and the No. 2 (Black/Yellow) terminals of the remote control box har- ness side 14P connector. -5. Test the oil pressure indicator light using the HDS pocket tester. Does the oil pressure indicator light blink? YES – End of the test NO – Perform “5. Oil pressure indicator line check”. REMOTE CONTROL BOX HARNESS SIDE 14P CONNECTOR WHITE/BLACK BLACK/YELLOW VIEWED FROM THE TERMINAL SIDE Is there continuity? YES – Repair open in the main harness. NO – Repair open in the remote control box har- ness. 5-23