BF135A•BF150A 3. MIL line check -1. Turn the ignition switch OFF and disconnect the MIL 6P connector. -2. Turn the ignition switch ON. Measure the voltage between the No. 2 (Yellow/Red) terminal of the MIL 6P main harness side connector and the engine ground. -5. Check for continuity between the No. 4 (Yellow/ Black) terminal and the No. 6 (Red/Blue) terminal of the MIL 6P connector. MIL 6P CONNECTOR MIL HARNESS SIDE 6P CONNECTOR YELLOW/BLACK RED/BLUE YELLOW/RED VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Substitute a known-good ECM and recheck. NO – The MIL is faulty or repair open in the MIL har- ness. VIEWED FROM THE TERMINAL SIDE Is there the battery voltage?
YES – Go to the step 3. NO – Repair open in the main wire harness. -3. Turn the ignition switch OFF and disconnect the ECM connector B. -4. Check for the continuity between the No.25 (Red/Blue) terminal of the ECM harness side connector B and the No.4 (Red/Blue) terminal of the MIL main harness side 6P connector. MIL HARNESS SIDE 6P CONNECTOR ECM CONNECTOR B WHITE/BLACK VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Go to the step 5. NO – Repair open in the main harness. 5-24