honda — Programmed Fuel Injection

BF135A•BF150A 5. ECT sensor 1 check -1. Turn the ignition switch OFF and disconnect the 2P connector of the ECT sensor 1. -2. Measure the resistance between the No. 1 and the No. 2 terminals of the ECT sensor 1 side 2P connector. • TP Sensor Troubleshooting MIL blinks 7 times. 1. Symptom reproduction test -1. Reset the ECM. -2. Turn the ignition switch OFF and connect the test har- ness. Hold the sensor connector connected. -3. Turn the ignition switch ON. -4. Measure the voltage between the B-7 terminal (+) and the A-2 terminal (–) of the test harness. ECT SENSOR 1 SIDE 2P CONNECTOR VIEWED FROM THE TERMINAL SIDE A-2 B-7 RESISTANCE Is the measured voltage 0.08 – 4.92V?

YES – Temporary failure (Disappeared) NO – Perform "2.TP sensor power supply line open circuit check". 2. TP sensor power supply line open circuit check -1. Turn the ignition switch ON. Measure the voltage between the No. 3 (Brown/White) terminal of the TP sensor harness side 3P connector and the engine ground. ENGINE COOLANT TEMPERATURE Is there the resistance corresponding to the engine coolant temperature? YES – Substitute a known-good ECM and recheck. NO – Replace the ECT sensor 1. TP SENSOR HARNESS SIDE 3P CONNECTOR VCC2 (BROWN/WHITE) VIEWED FROM THE TERMINAL SIDE Is the measured voltage 4.75 – 5.25V? YES – Perform "3. TP sensor signal line open circuit check".

NO – Repair open in the wire between the TP sen- sor and the ECM. 5-75