BF135A•BF150A 3. TP sensor signal line open circuit check -1. Turn the ignition switch OFF and disconnect the TP sensor connector. -2. Measure the voltage between the No. 2 (Red/Black) terminal of the TP sensor harness side 3P connector and the engine ground. 5. TP sensor ground line open circuit check -1. Turn the ignition switch OFF and disconnect the TP sensor 3P connector. -2. Check for the continuity between the No. 1 (Green/ Red) terminal of the TP sensor harness side 3P con- nector and the engine ground.
TP SENSOR HARNESS SIDE 3P CONNECTOR TP SENSOR HARNESS SIDE 3P CONNECTOR SG2 (GREEN/RED) THL (RED/BLACK) VIEWED FROM THE TERMINAL SIDE VIEWED FROM THE TERMINAL SIDE Is the measured voltage 4.75 – 5.25V? YES – Perform "4. TP sensor signal line short circuit check". NO – Repair open in the wire between the TP sen- sor and the ECM. Is there the continuity? YES – Perform "6.TP sensor check". NO – Repair open in the wire between the TP sen- sor and the engine ground. 6. TP sensor check -1. Turn the ignition switch OFF and connect the TP sen- sor 3P connector. -2. Measure the voltage between the B-7 terminal and the A-2 terminal of the test harness. 4. TP sensor signal line short circuit check -1.
Turn the ignition switch OFF and disconnect the TP sensor connector. -2. Check for the continuity between the No. 2 (Red/ Black) terminal of the TP sensor harness side 3P con- nector and the engine ground. TP SENSOR HARNESS SIDE 3P CONNECTOR A-2 B-7 THL (RED/BLACK) Is the voltage 4.49 – 4.85V when the throttle is fully open and 0.44 – 0.56V when the throttle is fully closed? YES – Substitute a known-good ECM and recheck. NO – Replace the TP sensor. VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Repair short in the wire between the TP sen- sor and the ECM. NO – Perform "5.TP sensor ground line open circuit check". 5-76