honda — Programmed Fuel Injection

BF135A•BF150A • CMP Sensor Troubleshooting MIL blinks 8 times. 1. Symptom reproduction test -1. Reset the ECM. -2. Start the engine and let it run at idling under no load. -3. Check the MIL. Is the voltage 4.75 – 5.25V? YES – Perform "4. CMP sensor signal line short cir- cuit check". NO – Repair open in the wire between the CMP sensor and the ECM. 4. CMP sensor signal line short circuit check -1. Turn the ignition switch OFF and disconnect the CMP sensor 3P connector. -2. Check for the continuity between the No. 3 (Green) ter- minal of the CMP sensor harness side 3P connector and the engine ground. Does the MIL come ON? YES – Check the pulse plate.

If it is normal, perform "2.CMP sensor power supply line open circuit check". If it is abnormal, replace the pulse plate and recheck. NO – Temporary failure (Disappeared) CMP SENSOR HARNESS SIDE 3P CONNECTOR 2. CMP sensor power supply line open circuit check -1. Turn the ignition switch ON. Measure the voltage between the No. 1 (Yellow/Black) terminal of the CMP sensor harness side 3P connector and the engine ground. TDC (GREEN) CMP SENSOR HARNESS SIDE 3P CONNECTOR VIEWED FROM THE TERMINAL SIDE IGP (YELLOW/BLACK) Is there the continuity? YES – Repair short in the wire between the CMP sensor and the ECM. NO – Perform "5. CMP sensor ground line open cir- cuit check".

VIEWED FROM THE TERMINAL SIDE 5. CMP sensor ground line open circuit check -1. Turn the ignition switch OFF and disconnect the CMP sensor 3P connector. -2. Check for the continuity between the No. 2 (Green/ Black) terminal of the CMP sensor harness side 3P connector and the engine ground. Is there the battery voltage? YES – Perform "3. CMP sensor signal line open cir- cuit check". NO – Repair open in the wire between the No. 4 fuse and the CMP sensor. 3. CMP sensor signal line open circuit check -1. Turn the ignition switch ON. Measure the voltage between the No. 3 (Green) terminal of the CMP sensor harness side 3P connector and the engine ground.

CMP SENSOR HARNESS SIDE 3P CONNECTOR LG1 (GREEN/BLACK) CMP SENSOR HARNESS SIDE 3P CONNECTOR TDC (GREEN) VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Perform “6. CMP sensor check”. NO – Repair open in the wire between the CMP sensor and the engine ground. VIEWED FROM THE TERMINAL SIDE 5-77