BF135A•BF150A • BARO Sensor Troubleshooting 3. BARO sensor signal line open circuit check -1. Turn the ignition switch ON. Measure the voltage between the No. 2 (White/Blue) terminal of the BARO sensor harness side 3P connector and the body ground. MIL blinks 13 times. 1. Symptom reproduction test -1. Reset the ECM. -2. Turn the ignition switch OFF and connect the test har- ness. Hold the sensor connector connected. -3. Turn the ignition switch ON. -4. Measure the voltage between the A-5 terminal (+) and the A-2 terminal (–) of the test harness. BARO SENSOR HARNESS SIDE 3P CONNECTOR PA (WHITE/BLUE) A-5 A-2 VIEWED FROM THE TERMINAL SIDE Is there 1.58 – 4.49V?
YES – Temporary failure (Disappeared) NO – Perform "2. BARO sensor power supply line open circuit check". Is the voltage 4.75 – 5.25V? YES – Perform “4. BARO sensor signal line short cir- cuit check”. NO – Repair open in the wire between the BARO sensor and the ECM. 2. BARO sensor power supply line open circuit check -1. Turn the ignition switch OFF and disconnect the BARO sensor 3P connector. -2. Turn the ignition switch ON. Measure the voltage between the No. 3 (Brown/White) terminal of the BARO sensor harness side 3P connector and the body ground. 4. BARO sensor signal line short circuit check -1. Turn the ignition switch OFF and disconnect the ECM connector B. -2.
Check for the continuity between the No. 2 (White/Blue) terminal of the BARO sensor harness side 3P connector and the body ground. BARO SENSOR HARNESS SIDE 3P CONNECTOR BARO SENSOR HARNESS SIDE 3P CONNECTOR PA (WHITE/BLUE) VCC2 (BROWN/WHITE) VIEWED FROM THE TERMINAL SIDE VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Repair short in the wire between the ECM and the BARO sensor. NO – Perform "5. BARO sensor ground line open circuit check". Is the voltage 4.75 – 5.25V? YES – Perform "3.BARO sensor signal line open cir- cuit check". NO – Repair open in the wire between the BARO sensor and the ECM. 5-80