honda — Programmed Fuel Injection

BF135A•BF150A 5. BARO sensor ground line open circuit check -1. Turn the ignition switch ON. Measure the voltage between the No. 1 (Green/Red) terminal of the BARO sensor harness side 3P connector and the engine ground. • IAC Valve Troubleshooting MIL blinks 14 times 1. Symptom reproduction test -1. Reset the ECM. -2. Turn the ignition switch OFF and connect the test har- ness. Hold the sensor connector connected. -3. Start the engine. Check the engine speed during idling. BARO SENSOR HARNESS SIDE 3P CONNECTOR SG2 (GREEN/RED) Is the engine speed 650 rpm or above? YES – Temporary failure (Disappeared) NO – Perform "2. IAC valve open circuit check". VIEWED FROM THE TERMINAL SIDE 2.

IAC valve open circuit check -1. Turn the ignition switch OFF and disconnect the IAC valve 2P connector. -2. Measure the resistance between the IAC valve No. 1 and the No. 2 terminals. Is there the continuity? YES – Perform "6. BARO sensor check". NO – Repair open in the wire between the BARO sensor and the engine ground. 6. BARO sensor check -1. Turn the ignition switch ON. -2. Measure the voltage between the A-5 terminal (+) and the A-2 terminal (–) of the test harness. IAC VALVE SIDE 2P CONNECTOR A-5 VIEWED FROM THE TERMINAL SIDE A-2 Is the resistance 8 – 12 ? YES – Perform "3. IAC valve short circuit check". NO – Replace the IAC valve. Is the measurement 2.76 – 2.96V?

YES – Substitute a known-good ECM and recheck. NO – Replace the BARO sensor and recheck. 3. IAC valve short circuit check -1. Check for the continuity between the IAC valve No. 1 terminal and the body ground. IAC VALVE SIDE 2P CONNECTOR VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Replace the IAC valve. NO – Go to the step 2. 5-81