BF135A•BF150A 3. VTEC signal line open circuit check -1. Check for the continuity between the spool solenoid valve harness side connector terminal and A-20 termi- nal of the test harness. • KNOCK Sensor Troubleshooting MIL blinks 23 times 1. Symptom reproduction test -1. Reset the ECM. -2. Turn the ignition switch OFF and connect the test har- ness. Hold the sensor connector connected. -3. Start the engine and let it warm up by running the engine at 5,000 min -1 (rpm) or more for 5 minutes or more under no load. -4. Check the MIL. SPOOL SOLENOID VALVE SIDE CONNECTOR A-20 Is there the continuity? YES – Perform "4. Symptom reproduction test".
NO – Repair open in the wire between the ECM and the spool solenoid valve. Does the MIL come ON? YES – Perform "2. Knock sensor signal line open cir- cuit check". NO – Temporary failure (Disappeared) 4. Symptom reproduction test -1. Disconnect the test harness and connect each con- nector securely. -2. Reset the ECM. -3. Start the engine and let it warm up by running the engine at 3,000 min -1 (rpm) for 5 minutes under no load. -4. Disconnect the neutral switch 2P connector. -5. Increase the engine speed gradually until it reaches 4,500 min -1 (rpm), and run the engine for a few sec- onds. -6. If there is any abnormality, substitute a known-good ECM and recheck. 2.
Knock sensor signal line open circuit check -1. Turn the ignition switch OFF and disconnect the knock sensor 1P connector. -2. Check for the continuity between the knock sensor har- ness side connector (Red/Blue) terminal and the test harness A-15 terminal. A-15 Is there the continuity? YES – Perform "3. Knock sensor signal line short cir- cuit check". NO – Repair open in the wire between knock sen- sor and the ECM. 5-83